Sound system for Seat Leon 5F (Seat sound system) DSp amplifier, front/rear speakers | V3 | OPTION

The ultimate sound boost for your Seat Leon 5F with Seat Sound System

DSP amplifier + new front and rear speakers + installation accessories

Compact DSP power amplifier: increased performance with simple installation

The very compact 6-channel power amplifier is a real powerhouse and can be integrated in no time at all via plug & play thanks to the cable set included in the scope of delivery. This provides the front and rear speakers and the subwoofer with plenty of power, giving you an unrivalled sound upgrade that really brings out the best in sound and bass. The power amplifier emits hardly any heat and can therefore be concealed next to the Seat power amplifier.

ATTENTION:

• Only suitable for Seat sound system, not for BEATS!
• Rear speaker system is only compatible with the 5-door version of the Seat Leon 5F, with the 3-door version these are not Plugs & Play and do not fit!
• The power amplifier can be used in conjunction with all factory loudspeakers and the factory subwoofer.
• The subwoofer control in the car radio is omitted, but we supply the level remote control instead. Installation is possible with both the "small" and the "large" sat nav.

Ready to go immediately

The right sound setup is already pre-installed in the integrated sound processor. You can make fine adjustments to the power amplifier in just a few simple steps. For a detailed explanation and support during installation, simply watch our YouTube video.

Plug & Play speaker system: The perfect partner for your power amplifier

Equip your vehicle with new front and rear speakers that are optimally amplified by the DSP power amplifier. Thanks to the Plug & Play concept, the speakers are also suitable for leased vehicles, as retrofitting is no problem.

Door insulation for clear sound

The door insulation supplied minimises background noise and improves the impulse response of the bass/midrange speakers at the front and rear. This makes the music in your Seat Leon 5F a real experience.

Optional: Subwoofer replacement for powerful bass

The original subwoofer can remain installed in the vehicle and now also has more power and therefore plays much more impressively than before. However, for all those who prefer even stronger bass and even more depth, we have a replacement subwoofer.

Simple installation thanks to Plug & Play

Installation is simple and can be done by anyone thanks to our YouTube video. A vehicle-specific wiring harness makes your work much easier. No cutting of cables, no time-consuming installation work!

Support and customer service

If you have any questions or problems, our support team is always available. Simply contact us by e-mail or telephone.

Scope of delivery:

• OPTION DSP6 power amplifier incl. level remote control for subwoofer
• Plug & Play loudspeaker system front and rear (incl. all adapter rings, plugs and screws)
• 4x aluminium butyl mats + 2x insulating foam mat (for front and rear doors)

Accessories:

Helpful (installation) accessories can be found next to the item description or at the bottom of the page in the "Accessories" tab.

Technical data DSP power amplifier

• Highly efficient 6-channel DSP amplifier
• Class GD
• 6-channel amplifier / 8-channel DSP
• 6 x 60 watts RMS (4 ohms)
• 4 x 60 watts RMS (4 ohms) + 1 x 120 watts RMS (4 or 2 ohms)
• Channels 5 and 6 are combined in mono mode
• Minimum impedance on all stereo channels: (3 Ohm)
• Minimum impedance in mono mode: 1.5 Ohm
• ADEP.3 diagnostic protection for problem-free connection to OEM radios
• Start/stop capable up to 5 sec. up to 6 volts
• High-level in (4 channels) with automatic on/off switch
• Frequency band: 20 Hz to 21k Hz
• Integrated 8-channel DSP processor with 358 kHz
• 2 channels line-out up to 3 Volt | 3.5mm jack
• 2 phase synchronous DC/DC converter
• A/D converter: BurrBrown
• D/A Converter: BurrBrown
• Operating voltage: 10.3 V - 17.5 V
• Power reduction to mid-power mode
• Minimised Dimensions for uncomplicated retrofitting
• 94 x 149 mm x 32 mm (118 x 149 mm with mounting bracket)
• 0.6 mA standby quiescent current
• Main connection: 20-pin Molex MiniFit Jr.
• Subwoofer connection: 4-pole Molex MiniFit Jr.
• Programming port for DSP-Eprom: RJ-45 modular jack
• Remote control connection: RJ-45 modular jack
• Power and Protect LED

Technical data front loudspeaker V-200

• 20 cm diameter / 2-way compo system Plug & Play
• 28mm silk dome tweeter
• 100 Watt RMS power
• 4 Ohm Impedance
• 91 dB Efficiency

Technical data rear speaker V-165

• 16.5 cm diameter / 2-way compo system Plug & Play
• 70 watts RMS power
• 3 Ohm Impedance
• 91 dB Efficiency
• 25mm silk dome tweeter